Thanks for the reply man. I did print the painless BOOK up but see, the previous owner of my Jeep had a shop put in the new painless wiring harness,but, what they did was left the old wires from the factory wiring harness and ran the painless right along the old, just leaving them there. Not to mention any names but they spliced just about every wire(including the one going to the coil!!!)
I basically wanted to get my jeep running again, this way I can drive it and work on it while I'm not driving it. That's why I need just the engine wiring diagram. So batt.,fuel pump,coil,MSD ignition & switch,alt,elec. fan,gauges,electric choke on carb and wire from steering column. That's about it correct? Thank you for taking the time to help me!
Take it easy!