HELP!! I have been looking for a good way to tilt the front end of a pickup, with a winch bumber....... I have done one other front end on a two wheel drive truck and built the brackets, even had the bumper tilt with it. Worked well but had to cut the fenders on the sides and box them in. I used a cone and socket to aline the fender to the hood in two places on each side with a rubber cone, that with a latch on both sides to keep things tight. This worked ok but not sure about an off road rig. Would like to have full fender wells and a tilt front end, Any Ideas on a clean way to do this and not have a rattle trap for a front end? Seen a telescoping front end, but have not a clue how they did it! Any suggestions would be great! Thanks Dusty