Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Chop the top on my 1947 Ford Pickup
View Single Post
  #103 (permalink)  
Old 11-02-2010, 11:18 AM
adantessr's Avatar
adantessr adantessr is offline
'23 T-Bucket Pickup
 
Last wiki edit: Troubleshooting ignition Last photo:
Join Date: Jun 2010
Location: South Charleston , WV
Age: 62
Posts: 1,559
Wiki Edits: 3

Thanks: 54
Thanked 24 Times in 21 Posts
Quote:
Originally Posted by hotwheels1
dang guys, i just couldn't imagine doing sheetmetal work with a torch. I worry enough about warping metal with a mig welder, let alone pure fire. And those pic's are great guys......hehehehe
Oh yeah . It kept a guy on his toes . Somewhere I have a full set of pictures of when I replaced the rusted out sides on our Dodge church van back in '82 using 22 gauge body metal sheets and brazing in the metal . This was in Michgan's Upper Peninsula and some of those (patches) were 12" wide by 6 feet long with no way to hammer and dolly them . Braze , quench , repeat . Long days . LOL . I must say it looked good when I was done .
Reply With Quote