Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Color Sand Nason Acrylic Enamel?
View Single Post
  #1 (permalink)  
Old 06-11-2012, 03:30 PM
CADI70's Avatar
CADI70 CADI70 is offline
Registered User
 
Last photo:
Join Date: Oct 2011
Location: SC
Posts: 25
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Color Sand Nason Acrylic Enamel?

I'm wondering if anyone has experience successfully color sanding Nason acrylic enamel? I've done it once before and ended up with way too many scratches and a dull finish. Just finished a paint job and the cars been sitting a few days. It's taken a long time and a few mistakes to get the paint right so I'm a little afraid of screwing it up. It's not bad, the trunk lid has a couple of bugs (gnat sized) and a little bit of orange peel in it. I'm considering just buffing, trunk only, with some compound next weekend. The last time I sanded I started at 1000 and went up to 1500 grit. Just ended up looking worse then when I started. Any thoughts?
Reply With Quote