Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - consew 226R
Thread: consew 226R
View Single Post
  #9 (permalink)  
Old 09-28-2011, 01:29 PM
goradal goradal is offline
Registered User
 
Last photo:
Join Date: Aug 2011
Location: Tulsa
Posts: 6
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Update

Love the machine, finished up my boat seats really came out nice.

I have since totally disassembled the table and stand, the stand was real rusty to the point of being pitted. I grinded and sanded and grinded and sanded until I was blue in the face. Anyway repainted it with a gray hammered looking paint and it looks great. The feet were pretty weak due to all the rust and grinding so I built some wooden block to bolt it to, this added some strength to the feet and will allow me to move inside the house if need be. I have also ordered a new top, was going to build one but after all the time spent on the legs just decided to purchase it. That has arrived and I have attached it to the legs added a new drawer and light and it looks like a new machine. Additionally I purchased a new servo motor and installed it, so basically I have about $800 into the thing probably more than I had originally planned but it is a really nice setup and should hold it value well.

One new question, how do you set the tension on the belt?
Attached Thumbnails
Click image for larger version

Name:	Bass Seat1.jpg
Views:	226
Size:	1.28 MB
ID:	58641   Click image for larger version

Name:	Bench Seat1 Full.jpg
Views:	237
Size:	1.54 MB
ID:	58642   Click image for larger version

Name:	Butt Seat1.jpg
Views:	192
Size:	1.22 MB
ID:	58643   Click image for larger version

Name:	Map pocket.jpg
Views:	193
Size:	1.88 MB
ID:	58644  
Reply With Quote