|
|
|
01-19-2006, 03:28 PM
|
||||||
|
||||||
|
Corvette rear end in Ford
I am putting a C4 rear end in my 37, I have narrowed it and replaced the uni-spring and put in Aldin coil overs. Having trouble getting chassis level, I have the coil overs set up at same angle and same amount of turns on springs. The chassis with the body on sits about 1/4" out of level from side to side. Any ideas or am I being totally anal. I have checked tire pressures and aligned best I can with measuring multiple ponts and squareing wheels to floor. Been banging my head on this for a while now. Its not a show car but it will be a very nice driver, so I want it to sit right and not be a problem. Any feed back will be appreciated
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ford 9" rear end | stangfiend | Engine | 4 | 10-10-2004 03:30 PM |
| Ford rear end | genewa1 | Transmission - Rearend | 2 | 10-06-2003 08:45 PM |
| 1955 Ford Wagon Rear End . . . | TorqueU | Transmission - Rearend | 2 | 10-04-2003 11:33 PM |
| corvette rear end in a street rod | troy-curt | Transmission - Rearend | 4 | 06-28-2003 07:08 AM |
