Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - this could get ugly. pontiac/frankenstein
View Single Post
  #17 (permalink)  
Old 09-05-2012, 05:02 PM
robhardy's Avatar
robhardy robhardy is offline
Registered User
 
Join Date: Jun 2011
Location: alabama
Posts: 67
Wiki Edits: 0

Thanks: 1
Thanked 0 Times in 0 Posts
just went to edelbrock's site. it says that intake is for 3500 to 7500 rpm. i thought i read that it was lower rpm than that. is that really a good match for a big block?
it's also a single plane manifold. that's more of a track design, isn't it?
i've used performers or performer rpm's on all my fords.
i'm not looking to go 150 mph. if i want to do that i'll buy a vette or something that sits a 1/2 inch off the ground.
i'm really curious to see what's inside of this thing. again, i know squat about pontiac engines, so maybe that intake is a better fit than i think. i guess it depends on how it matched the cam and i don't know what that is yet.
sorry about rambling, just thinking that i would have built the engine to start making power before 3500 rpm.
Reply With Quote