Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Craftsman's Twin Cutter?
View Single Post
  #4 (permalink)  
Old 12-06-2005, 01:55 PM
astroracer astroracer is offline
STUPID is as STUPID does...
 
Last wiki edit: Crankshaft Coalition Wiki Last photo:
Join Date: Nov 2003
Location: Stupidville, USA
Posts: 1,747
Wiki Edits: 1

Thanks: 11
Thanked 87 Times in 81 Posts
I've been cutting .125 & .156 wall tubing and 10ga. sheet with it and I see no reason why 3/16th's would challenge it.
You have to use one to understand that there is NO chatter... It cuts with a smooth action and, if you can control the cut well enough the ends that were cut look like they were machined...
Reply With Quote