Hot Rod Forum banner

Crane Cams point conversion

1K views 1 reply 1 participant last post by  fred56 
#1 ·
I recently installed a Crane points conversion CR-1 in a 1966 SBC 283. My problem is I misplaced the instruction sheet before I was done and I need to know one more thing. Since I replaced the points do I still need the ballast resistor or would keeping it cut down on the coils performance(stock coil)?
Thanks - Jerry
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top