|
|
|
02-18-2007, 04:20 PM
|
||||
|
||||
|
Custom driveshaft
Hi
I'm a new member of Hotrodders and was hoping someone could advise me on companies that make custom drive shafts. I'm building a 32 Ford 3 window coupe with a SBC and th350 tranny. I need to get a drive shaft made up. I came across a company called Rescission Shaft Technologies while searching the web. Does anyone have any experience with this company? Thanks Legacy 
|
|
02-18-2007, 06:14 PM
|
||||
|
||||
|
custom driveshaft
I dont know where in md. you are located,but if you are near any fair sized city there should be a driveshaft shop that can build you a new shaft.I would advise getting it done locally if possible,in case of problems. I work in a shop in nw.pa that builds driveshafts,we just built one last week for a 29 roadster with a 327 and a turbo 350 trans. I think a complete new shaft(yokes,tube and ujoints) was about $160-$175.
|
|
02-19-2007, 04:35 AM
|
||||
|
||||
|
Sounds like good advice. Thanks very much 39 Chev.
By the way, I'm located in Southern Maryland, about 29 miles south of Waldorf, (biggest near by city). Legacy
|
|
02-19-2007, 07:33 AM
|
||||||
|
||||||
|
I agree, get it fabricated locally. That way if there is any problem it can rectified more easily.
Vince
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How long is your driveshaft? | MotorCityCarMan | Transmission - Rearend | 1 | 06-23-2006 06:30 AM |
| Multi-section driveshaft | ckucia | Transmission - Rearend | 23 | 05-07-2006 12:01 PM |
| 1986 or somewhere around there s10 driveshaft angle problems | fumplet | Transmission - Rearend | 10 | 01-16-2006 09:20 PM |
| Driveshaft measurement | 71gtx | Transmission - Rearend | 6 | 01-11-2004 11:00 AM |
