Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - cutting square aluminum tubes
View Single Post
  #1 (permalink)  
Old 10-27-2009, 06:57 PM
oldcpecdr's Avatar
oldcpecdr oldcpecdr is offline
Registered User
Last photo:
Join Date: Nov 2005
Location: Massachusetts
Posts: 149
Wiki Edits: 0

Thanks: 0
Thanked 3 Times in 3 Posts
cutting square aluminum tubes

I need to cut some square aluminum tubing, 1 inch x1 inch thinwall. Any suggestions on how to use my chop saw or table saw to get nice square ends ? Will an abrasive disc clog ? Carbide tipped saw blade with lots of teeth work?

Thanks Mike B
Reply With Quote