Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Cylinder head fixture for Drill Press
View Single Post
  #1 (permalink)  
Old 11-06-2012, 03:13 PM
zildjian4life218's Avatar
zildjian4life218 zildjian4life218 is offline
Listen and Learn
 
Last wiki edit: DIY junkyard electrical fan controller
Last journal entry: SBC 305 Twin Turbo
Last photo:
Join Date: Dec 2008
Location: WNY/Rochester, New York
Age: 25
Posts: 1,588
Wiki Edits: 7

Thanks: 44
Thanked 8 Times in 8 Posts
Cylinder head fixture for Drill Press

I have been modifying a couple heads here and there for screw in studs and larger springs and higher valve lifts. I was wondering if you guys have any good ideas on building a fixture that will allow me to do this on the drill press. I have been doing them with a variable speed corded drill and im just looking at a more efficient way to do these and also I can do it with a consistent speed and pressure if i do it with a drill press. Im looking at something that I can bolt to the table and fasten a head to it. 99.9% of what I do is SBC so I will build it for that.

Any ideas on what is available out there on the market for me to maybe purchase directly? I can make it but If I can find something like this already built for a reasonable price it will probably be worth it.

Thanks!
Reply With Quote