[steve7589]

could someone please run this combo for me
350 L98 motor with iron heads
zz4 roller cam i dont know the specs hopefully someone does
edelbrock rpm intake
holley 650 dp carb
full length headers

im trying to end my debate on running this or my 327 dont want to start a 327/350 war cause i see its been over covered.this combo will be going in a 90 camaro.thanks,steve

[53_belair]

What heads are you running? Just the stock L98s?

293hp@5000
351tq@3500
160cc ports, 9.1:1comp is what I get.

[cabowabo]

bore and stroke
cubic inch

cyl heads
cc's ?
porting -none-mild-race-full race
int val dia size
exh val dia size
comp ratio

camshaft
lifter type-hyd.-hyd. roller.-soild-roller
int dur
exh dur
basic timing 4-6- 10-20 ?
rocker design -roller -stamped-roller tip
int val lift
exh val lift
lobe seperation

carb. size
pleunm design-single -daul-t ram
spacer height if any
exhaust -headers-dual-single-high flow dual-stock

total timing -28-32 ?

fuel octane

[steve7589]

stock l98 heads
might go with vortec though

[Blazin72]

Stick with the 350 man. All else being the same, 23 more cubes means more power and torque across the board...

[steve7589]

Originally Posted by Blazin72

Stick with the 350 man. All else being the same, 23 more cubes means more power and torque across the board...

thats what im thinkin i might do the 350 with vortec heads,zz4 cam or gm hot cam rpm intake and 650 dp im just trying to get some numbers for hp and trq even some round about numbers,that would be the deciding factor

[StrokedSBC]

Performance Trends show 395 ft.lbs. at 4000, and 350 at 5200.

Throw on the Vortec's and add about .9 compression and it goes to 410 ft.lbs at 4000 and 375 at 5400.