Hot Rod Forum banner

digital dash gauges

2K views 2 replies 3 participants last post by  z3pr 
#1 ·
I am interesting in converting my dash (23 t-bucket )into all digital gauges.Right now the gauges that are in there are the standard machanical gauges typical in most 23-t's.need to know what has to be done,do I need to change all the sending units ? this is all new to me,I have basic electrical knowledge.but lost when it comes to this..gauges would be,gas,oil,water rpm,mph,alt.the engine is a ford 302,need some help
joe
 
#2 ·
gauges

Joe, I put them in a 40 chevy. The kit came with all the sending units. Problems, the gas read in % age, which wasn't bad, except when you filled the tank, it showed 10, then went down to 1 then to 99. I never found out where 0 was, I always filled it at 30. The oil pressure was all over the place. temp worked well as did volt meter. Wished I went with antique gauges. To each his own. lol
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top