|
|
|
03-05-2011, 09:19 AM
|
|||||
|
|||||
|
dipstick tube
Can someone tell me how to remove this tube from the block of 65 327? I've tried pulling it out by hand and prying on the lip with a screwdriver but can't get it to budge. It appears as if it just presses in because there isn't any type of fastener holding it in. I'm afraid if I put to much pressure I might break it, I need to get it out to install a set of headers.
Thanks 
|
|
03-05-2011, 03:30 PM
|
||||||
|
||||||
|
Pull it out. Nothing fancy.
|
|
03-05-2011, 03:49 PM
|
||||||
|
||||||
|
Broken off more of those than I care to mention.....spray some penetrating oil around it and wiggle it gently.
__________________
Ontario Rodders
|
|
03-05-2011, 04:28 PM
|
|||||
|
|||||
|
Heat will help to loosen it.Don't get it red hot ,
|
|
03-05-2011, 08:20 PM
|
|||||
|
|||||
|
5/16 bolt down the tube and a set of vice grips wiggle gently
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| dipstick & tube | Oldguy48 | Engine | 1 | 06-24-2010 06:35 PM |
| 92 sbc dipstick tube | Eric64 | Engine | 1 | 05-10-2009 03:14 PM |
| How I got the dipstick tube out. | user151 | Engine | 5 | 03-17-2009 08:30 AM |
| Dipstick Tube Won't Seat | riesman20 | Engine | 10 | 09-10-2007 07:14 PM |
| Getting the dipstick tube out | MartyMart9@aol.com | Engine | 6 | 05-27-2005 02:17 PM |
