Hot Rod Forum banner

distributor installation

803 views 1 reply 2 participants last post by  poncho62 
#1 ·
I have a 350 chevy engine which I switched out an old intake and carb. and bolted down a eldebrock highrise intake and and eldebrock carb. I am having problems getting it to run. I cant even get it to backfire. I set my timing at 10 degrees above tdc, then inserted my distributor with the rotor pointing towards the #5 cylinder, slid it in and put my wires on in firing order. I'm getting spark, but indication of the engine starting. Any Suggestions?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top