Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - distributor not seating properly on intake(sbc)
View Single Post
  #6 (permalink)  
Old 03-08-2010, 08:21 PM
cobalt327's Avatar
cobalt327 cobalt327 is offline
WFO
 
Last wiki edit: Intake manifold
Last journal entry: 1980 Malibu Wagon
Last photo:
Join Date: Mar 2009
Location: Atlanta
Age: 59
Posts: 5,037
Wiki Edits: 1616

Thanks: 128
Thanked 595 Times in 545 Posts
Quote:
Originally Posted by 84CHEVYSWB
i did have a different distributor in it but bought a hotter one. the heads were surfaced and the block was decked and honed. i have it in as far as it will go. it fires right up and runs good except that it leaks oil from there.
No sweat. Run down and get a Mr. Gasket #720-6059 (Jegs) Distributor Shim Kit For Chevy V8- these go between the dist and intake, nylon for milled heads/intake. $5.99/kit.

Last edited by cobalt327; 03-08-2010 at 08:25 PM. Reason: Price change.
Reply With Quote