Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - double d shaft
Thread: double d shaft
View Single Post
  #15 (permalink)  
Old 12-10-2012, 06:54 AM
JOHNSHENOUDA JOHNSHENOUDA is offline
Registered User
 
Last photo:
Join Date: Oct 2012
Location: Detroit Area
Posts: 94
Wiki Edits: 0

Thanks: 7
Thanked 3 Times in 3 Posts
Prostcelica,

Thanks for reassuring me. I figure at the end of the day it will actually be way stronger since it will basically become a solid rod as opposed to hollow. The weld will basically just stop the smaller rod from sliding out. Seems to me that 3/4 inside of 1" with fillet welds must be stronger than those wimpy screws that go through the u-joints. Thanks again.
Reply With Quote