Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - driveshaft shortening
View Single Post
  #3 (permalink)  
Old 05-13-2002, 05:19 PM
dmorris1200's Avatar
dmorris1200 dmorris1200 is offline
doesn't play well with others
 
Last photo:
Join Date: Feb 2002
Location: Maine
Age: 49
Posts: 1,834
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post

Approx. 1 inch between where seal rides and flange starts. That's why I was thinking of cutting a little extra 'cause she's pretty far into the trans but wasn't sure if she needs to be in as far as possible without bottoming into the trans or could she be out a bit further and be ok. Also if I go causious and need to shorten more can the shaft be shortened twice or will I need to find another shaft? So many questions for one job eh? <img src="confused.gif" border="0">
__________________
BUILT FORD TOUGH
Reply With Quote