I have this E-Z Power converter For over 10 years & the package got separated from the unit.

hooks up to the Alternator & converts to 100 AC

I know I put the installation instructions some where but it seems I hide them so well I can't even find them !

It is/was made in Venice, Caif. by ANES electronics.

Any one know how /where all these wires should go?


Here are some pixs to further the mystery.

Or should I put it up with my Antique Tool collection?





R

Attached Thumbnails

         

__________________
"SlowRide66"

"Illegitimis non carborundum"
Don't let the bastards grind you down!

Crankshaft Coalition Master List of Hotrodding Forums

Hey Rob, maybe you could email this guy on eBay and ask for a copy of the instructions? Looks like a very similar one and old too! LOL

Mark

Doc here,

Give ANES a Call..ask for a copy fax or email.

If you screw up and let the factory installed smoke out..you can get another on EVIL BAY for $10 Fazools..

I DO however have my doubts about it though as a "3000 Watt" Converter ...I have an 1800 watt converter that is 16 inches by 7 inches and is PURE heatsink! (and for very good reason) and will drain a Full charge battery in 30 minutes under FULL load. And it cost me $265 Fazools.. and runs 6 Gauge DC power wires!

Doc

__________________
Aftermarket Solutions
Electronic & Electrical
Innovations

I think it will go with the antique tools .

If I need serious 100 power I'll bring the Genny or put one of them HF Genny units under the hood .
As soon as I really give up on it it will she up

I know I seen tat on evil bay too funny I searched for hours a few months ago & NADA!!!!!!.

You know Doc If I was you I would hold onto them fazooles & whatchamabingies they are getting hard to find,. the Gubmnt is cycling dem ouwt!



Seriously Thanks Y'all



R

__________________
"SlowRide66"

"Illegitimis non carborundum"
Don't let the bastards grind you down!

Crankshaft Coalition Master List of Hotrodding Forums