Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Early Ford Spindles -- Bolt Patterns
View Single Post
  #1 (permalink)  
Old 09-29-2007, 03:10 PM
Dugg's Avatar
Dugg Dugg is offline
My compass doesn't point North
 
Last photo:
Join Date: Apr 2007
Location: in the hills of Colorado
Posts: 148
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Early Ford Spindles -- Bolt Patterns

I have a set of early Ford spindles and I pretty much thought the hole pattern for the backing plates was all about the same. The right spindle has two tie rod end holes. I've already made wheel bearing spacers and caliper mounting brackets for GM calipers and rotors for these spindles.

I just bought Chassis Engineering forged steering arms and discover they are a different mounting bolt pattern then my spindles.

Is there information or drawings somewhere to help me determine what I have now and before I buy CE's forged spindles?
Reply With Quote