Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Eastwood Extreme Chassis black
View Single Post
  #18 (permalink)  
Old 04-28-2013, 07:54 PM
Ed M. Ed M. is offline
Registered User
 
Join Date: Mar 2013
Location: McKeesport Pa. area
Posts: 13
Wiki Edits: 0

Thanks: 1
Thanked 0 Times in 0 Posts
Blown paint

Just came from the garage a little earlier , trying to clean-up a little. While I was trying to organize some items, I rubbed up against the rad support that I had re-painted again that the paint had come off the first time. I didn't think that I had rubbed up against it with what I was moving hard enough to scratch any of the paint off, so the temptation off the air test came back. And again, the paint just blew off as did the first time. I also looked at the inner fender-wells that I had sprayed also, and the same thing.( These were new inner fenders) Cannot figure this one out. The epoxy primer was still on the pieces. I had left a good 10 plus hours before I painted these parts. I've been using the same epoxy primer for many years and had never had this problem. I guess time to call Eastwood again.

Last edited by Ed M.; 04-28-2013 at 08:01 PM.
Reply With Quote