The Edelbrock #1405 Carb - again
This is a follow-up to a previously sent post about switching the fuel inlet on a Edelbrock 1405 4-bbl carb.
Sent an E-mail to Edelbrock and much to my surprise they answered me almost immediately. The subject was switching the fuel inlet from right to left. Bad news - I'd have to buy an AVS carb to do this.
The other thing that happened was that I decided to try and see if I could run Russsel Braided line and fittings for the look of it - this is pretty much a cruising car and not high performance by any means. That in mind I wanted to switch back to rubber fuel line under the firwall (where it's out of sight) and go back to the tank (NOT fuel cell) through the filter and fuel pump (4 more -AN fittings at $8 - $12). What this set-up would have required would have been a -6AN hose end with a -6AN screwed fitting to 5/16 barb adapter which I doubted they even made but when I called the speed shop to see if there was such a part the unnamed LADY there told me "oh yeah" they had it after driving 38 miles I found out that if anyone made it, they didn't have it. - Crap - Afternoon wasted. Went to Auto Zone and bought 20 feet of black rubber fuel line and 6 clamps for around $30.00 - to Hell with it.
If anyone has any suggestions on "fancying up" the fuel inlet I'd like to hear them.
'****tail" Charlie Smith
Try: Part #651100 w/filter,#651099 without.
|All times are GMT -6. The time now is 03:09 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.