Edelbrock Performer rebuild

GMR · #1 (**permalink**) 12-29-2012, 09:11 PM

I'm about to soak the bottom half in Napa carb cleaner that comes in a gallon can. Wasn't planning on removing the throttle shafts and primary plates. Did remove the secondary plates as they are not steel, don't know what they are made of. What do you think - should I remove the shafts?

hcompton · #2 (**permalink**) 12-29-2012, 10:35 PM

Quote:

Originally Posted by GMR

I'm about to soak the bottom half in Napa carb cleaner that comes in a gallon can. Wasn't planning on removing the throttle shafts and primary plates. Did remove the secondary plates as they are not steel, don't know what they are made of. What do you think - should I remove the shafts?

You can get the exploed diagram from the edel site. Best to check it out to be sure. Or just use some carb cleaner in a can and some small wire to poke thru the holes its not a complex setup should clean up easy.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Edelbrock performer or edelbrock thunder avs?	eric32	Engine	1	09-07-2009 11:25 PM
Edelbrock Performer vs Performer RPM vs Air Gap RPM	Regal Beagle	Engine	10	02-16-2009 07:07 PM
Comparing 2 Edelbrock carbs ....EDELBROCK PERFORMER and AVS THUNDER	Calderone	Engine	6	09-28-2008 09:24 AM
Edelbrock Performer Cam vs. ...	hillman88	Engine	21	05-13-2006 08:06 AM
edelbrock performer upgrade	scott ticknor	Engine	8	07-25-2003 08:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)