Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Electrical disconnect
View Single Post
  #7 (permalink)  
Old 07-07-2012, 10:09 AM
Irelands child's Avatar
Irelands child Irelands child is offline
Registered User
Last wiki edit: Ford engine specifications Last photo:
Join Date: Jan 2005
Location: Upstate New York
Posts: 5,368
Wiki Edits: 8

Thanks: 59
Thanked 530 Times in 410 Posts
I used a Cole-Hersee 24200 latching solenoid and wired it according to their suggested wiring diagram(no pilot light). I have a thread from several months ago about how I did it, but the schematic included that I drew afterwards was wrong so removed. The Cole-Hersee remote battery disconnect, shown in the attached is, in general, what I used: Special Solenoid Applications | Cole Hersee - Littelfuse

It works just fine and is mounted, except for the actuating SPDT switch along with the battery in the upholstered box you see in the header above or in the scroll of the battery bracket below
Irelands child
Reply With Quote
The Following User Says Thank You to Irelands child For This Useful Post:
krruzer (07-09-2012)