Engine Analyzer Pro v3.9
Comp cams grinds their cams at 4 degrees so when putting them in Engine Analyzer Pro v3.9 should they be put in at 0 degrees or at 4 degrees?
This would be the cam installed in the engine "straight up".
Someone correct me if I'm wrong on this please.
|All times are GMT -6. The time now is 06:25 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.