Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Engine/Cam Breakin
View Single Post
  #1 (permalink)  
Old 10-27-2009, 08:21 PM
jmichaelre jmichaelre is offline
Registered User
 
Join Date: Oct 2009
Location: Nebraska
Posts: 176
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Engine/Cam Breakin

I'm building a fresh 350 and should be done in about a week as long as my parts arrive. As far as the breakin I was going to break in the cam based on the instructions by edelbrock, but they didnt specify anything about engine oil during breakin. As far as the rings go, I have moly faced rings and the college I had machine it for me knew that I was using these rings and told me that they would put a fine plateau finish on the cylinders and said that they should seat during cam breakin or very shortly after. Everyone, I have talked to said to use straight 30 until the rings seat, but Im worried that since its so thick and I need this engine in the truck in the next month that temps will be around 40 degrees and I dont want to starve the cam of oil.
Reply With Quote