Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - engine mounting
Thread: engine mounting
View Single Post
  #3 (permalink)  
Old 10-28-2012, 08:11 AM
delawarebill's Avatar
delawarebill delawarebill is offline
Registered User
 
Last photo:
Join Date: Mar 2009
Location: delaware
Posts: 1,250
Wiki Edits: 0

Thanks: 16
Thanked 63 Times in 63 Posts
eng to frame

u didn't say, but is the cab off the frame.. makes this job alot easier if working with a bare frame.. when i built my bucket i used a stock 8" ford rear. they come with an offset, so the driveshaft is off center a little. but i did center the eng/trans in the frame making sure the intake was level so i could measure the downward angle of the tranny to allow me to raise the nose of the rear... my d-shaft is about 18" long and no vib at all..
Reply With Quote