Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Engine Painting Question
View Single Post
  #55 (permalink)  
Old 09-04-2012, 07:11 PM
cdminter59 cdminter59 is offline
Registered User
 
Last photo:
Join Date: Jan 2011
Location: Hopewell, Va
Age: 62
Posts: 1,186
Wiki Edits: 0

Thanks: 0
Thanked 117 Times in 113 Posts
Quote:
Originally Posted by robertalive View Post
man, good looking paint getting laid over here.i try nice little sand out with 320 maybe 220, but thats a little harsh,i admit that.i like the rattle cans on well prepped surface.what you guys think bout header paint,or just wrap them.i wish there was a drying resin to wrap and set it with tie straps till the gloss resin dries.some of that 1500 degree paint needs the engine or headers to run and then it cures.Eastwood stuff is Boss,i got a free shipping credit with them.i wonder how that brush on looks. p.s when is everyone gonna get anodizing down pat to hit the pulleys,aluminum.maybe the rotating assembly ,that process is bulletproof.bye
Heat them up with a propane torch before painting. Hit them again while it drying. It will bubble up a little but will lay back down.
Reply With Quote