|
|
|
03-20-2006, 06:04 PM
|
|||||
|
|||||
|
engine position
installed engine in chassis have to make a new trans crossmember does the engine get setup level at ride height or down in the back 3 degrees
|
|
03-20-2006, 06:54 PM
|
|||||
|
|||||
|
from the factory the manifold carb mount is angled forward 3* so the carb will sit leval @ 3* to the rear of the car, they put the engines 3* to the rear of the car so the trans hump isn't so big
|
|
03-20-2006, 08:36 PM
|
|||||
|
|||||
|
At ride height, put a level on the intake and make it level. The 3 to 5 degrees of motor tilt is designed into the intake.
|
|
04-13-2006, 03:02 PM
|
||||||
|
||||||
|
Quote:
Engines tilt down because of the driveshaft U-joint angles necessary for suspension travel.
|
|
|
| Recent General Rodding Tech posts with photos |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| the history of chevy v8's | savman1 | Hotrodders' Lounge | 43 | 03-02-2012 06:57 PM |
| ENGINE BALANCING | NAIRB | Engine | 14 | 09-06-2011 08:22 PM |
| Build for Hp or Torque? | Venturat | Engine | 76 | 09-23-2008 10:22 AM |
| 4.6 DOHC overheating | oldred | Engine | 14 | 07-10-2005 10:23 PM |
| Distributor Clock position (long) | Screwy Lewy | Engine | 7 | 07-16-2003 01:25 AM |
