Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Engine stand that allows flywheel and clutch access
View Single Post
  #1 (permalink)  
Old 04-04-2013, 09:45 PM
WICruiser WICruiser is offline
Registered User
 
Join Date: Feb 2013
Location: Chilton, WI
Posts: 68
Wiki Edits: 0

Thanks: 9
Thanked 6 Times in 5 Posts
Engine stand that allows flywheel and clutch access

I am building a SBC for installation in a Jeep conversion project but the engine stand I have, and most eveyone I see grab the engine on the bell housing end.

I need to install a flywheel, clutch, check bell housing for run out to the crank, etc. but can not do that on the current stand.

Does somebody make a stand that comes off the engine mount locations and ?? to allow access to the back end of the engine?
Reply With Quote