Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - engine swap 36 cord to GM V/8 FRONT WHEEL DRIVE
View Single Post
  #103 (permalink)  
Old 09-02-2012, 10:41 AM
Jerrycord Jerrycord is offline
Registered User

Last journal entry: jerrycord's journal Cord restomod
Last photo:
Join Date: Jul 2012
Location: BEVERLY,MA
Posts: 63
Wiki Edits: 0

Thanks: 25
Thanked 1 Time in 1 Post
Originally Posted by OneMoreTime View Post
One of the critical dimensions is the width of the Cord front end hub to hub..That will be most helpful in determining what a good donor will be..I am concerned that the Toronado front end would be too wide and cause a great deal of expense in rework to make it fit..

hi Sam, thanks for your great posts,the front track of the cord is 58'' the toro is 63.5" i don't have hub to hub meas.(my cuz has them at his shop),we are probably going to use a 350 crate eng. big blk. was never considered, looking at later 4 spd. toro auto. check out cords ,hollywood ghrams ,hupmobile skylarks pg.2 #29 this site to see it done. gotta go, thanks again sam, regards jerry
Reply With Quote