Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Exhaust tubing cutter, must have tool!
View Single Post
  #8 (permalink)  
Old 08-20-2011, 08:34 AM
MARTINSR's Avatar
MARTINSR MARTINSR is offline
Brian Martin,Freelance adviser
 
Last photo:
Join Date: Jun 2004
Location: San francisco bay area
Age: 55
Posts: 12,671
Wiki Edits: 0

Thanks: 614
Thanked 948 Times in 848 Posts
Quote:
Originally Posted by deadbodyman
I'm pretty handy with a sawzall too but I sure wish I had one of those when I replaced all the cast drain pipe in my house.I looked everywhere for one of those cutters,ended up using an electric side grinder with big cutting wheel ,it worked but it was slooooow and all the sparks were pretty scary when your surrounded by 50 yr old wood,not to mention the big wheel wont fit with the gaurd on,I wore welding gloves and prayed.
When I did my bathroom remodel last summer I found that car tools made some great house tools. I ran an air hose over to the house and used my die grinder with a cut off disc a lot. My Matco hot rod die grinder with the swivel head on it was a life saver!

Then when I leveled my floor I used my 8" orbital ND 900. The friggin paint dept would have accepted that floor for primer it was so flat! LOL

Brian
Reply With Quote