Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Experienced opinions please
View Single Post
  #6 (permalink)  
Old 05-09-2004, 10:09 PM
Magikal's Avatar
Magikal Magikal is offline
How can it go faster?
 

Last journal entry: Been a long Winter
Last photo:
Join Date: Jan 2004
Location: North Idaho
Age: 37
Posts: 240
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
ok, so should I have the block bored out .030 or would more or less be better? And what about the line hone? What numbers are best here? I will go with the decking down to .005 and be sure of the .039 gasket (particular brand for these?).

Can the stock heads be either sent to the shop to be upgraded or will I need new heads completly? next, what cam/lifter setup will work best with this combo?

I just want to have a plan before machining so that all the necessary stuff can be done to it in one trip. I want to do this right....hehe

Thanx guys!!
Reply With Quote