Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - f-bird'88 lift rule 350-vortec
View Single Post
  #10 (permalink)  
Old 05-31-2008, 03:41 PM
CNC BLOCKS NE's Avatar
CNC BLOCKS NE CNC BLOCKS NE is offline
CNC Blocks Northeast
 
Last photo:
Join Date: Sep 2006
Location: NORTHEAST
Age: 54
Posts: 1,427
Wiki Edits: 0

Thanks: 1
Thanked 15 Times in 15 Posts
Quote:
Originally Posted by F-BIRD'88
One day I'm going to do the plant tour there and see just what they do.
They build the LS V8 motors and the V6's there. Used to do the Gen 1 vortec V8 motors before. My friends dad was a lead hand there years ago and would know exactly what they do/did...don't. Used to get us lots of cool SBC engine parts for building our hot rods, way back.

I don't doubt for a minute that you can and do improve on GM's crate motors but I'm assuming this posters motor is low mileage and in good overall condition and should be fine for a low buck budget build up. Got to keep the costs in check or its no longer a "budget build."
I didn't see any where that this was a budget build!!!!

In most cases budget builds don't come out as good as non budget engines as have seen quite a few budget engines over the years that other shops have built on a budget and the customers are not happy with the results and in most cases they were promised they would be happy with the power. So we have seen more then one guy rebuild there engine the right way.

But remember we get calls on the bad ones not on the good ones.

Last edited by CNC BLOCKS NE; 05-31-2008 at 04:04 PM.
Reply With Quote