Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - f-bird'88 lift rule 350-vortec
View Single Post
  #33 (permalink)  
Old 06-01-2008, 07:44 PM
machine shop tom machine shop tom is offline
King of my Man-cave.
 
Last photo:
Join Date: Nov 2003
Location: Michigan
Age: 55
Posts: 2,901
Wiki Edits: 0

Thanks: 4
Thanked 16 Times in 13 Posts
Quote:
Originally Posted by F-BIRD'88
Cannot guarante that the hyper H345NP piston will have a 1.56" pin height.
The F-M book specs are 1.54" for the plane cast 345 piston and 1.56" for the hyper version. (I'm of the opinion this is a typo based on my past H345NP piston measurments.)

My old 350 had the hyper "H345np-60" pistons and had a 1.54" measured pin height. I measured myself when we tore the motor down for repair.
My block was decked a lot lot. Piston was .018" down the bore at TDC.
I have a set in the shop I'll measure tomorrow (if I remember). Somebody PM tomorrow morning (so I don't forget).

tom
Reply With Quote