Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Fabricating Aluminum Intake Manifold, need help
View Single Post
  #4 (permalink)  
Old 12-30-2012, 03:02 PM
ryankalel ryankalel is offline
Registered User
 
Last photo:
Join Date: Feb 2007
Location: Moab, Utah
Posts: 53
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Thank you for the replies.

Because the intake and the exhaust are on the same side I have been wondering about throttle body and plenum on the other side of the engine with the runners going over the top of the valve cover and then doing a 180 to the intake valve. I am a little leary about the 180 turn.

Here is the stock intake look. With a turbo in there it will be tight.

This is from another forum, but the basic design of what I am thinking about.
Reply With Quote