Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Fabricating Aluminum Intake Manifold, need help
View Single Post
  #15 (permalink)  
Old 01-05-2013, 02:12 PM
Project89's Avatar
Project89 Project89 is offline
Registered User
 
Last photo:
Join Date: Oct 2011
Location: utah
Posts: 976
Wiki Edits: 0

Thanks: 12
Thanked 33 Times in 30 Posts
here one o fthe ones i built . i reused the stock lower and middle section but did a whole new top

heres the cutup stocker

and what i made










urs will be much simpler to make over what i made for my car

for the plenum u want a flat bootom were the runners meet it, and u want all entrys bellmouthed , then use a half round plenum , u can tune runner lenght a lil bit to fine tune the intake

what i would do is make the plenum bolt to the runners , so u can make 2-3 diff sets of diff lenght runners and see what works best
Reply With Quote