Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Fabricating a tranny cross member....
View Single Post
  #10 (permalink)  
Old 01-25-2013, 08:16 AM
NEW INTERIORS's Avatar
NEW INTERIORS NEW INTERIORS is offline
Believe in yourself !!!!!!
 

Last journal entry: 41 WILLYS FRAME
Last photo:
Join Date: Jul 2007
Location: In My Shop..
Age: 49
Posts: 10,209
Wiki Edits: 0

Thanks: 1,393
Thanked 648 Times in 472 Posts
Look at the first picture,, Think of that angle iron being the bottom lip in your car.. You can do something like that one...That car had a big block in it with a lot of HP.. didn't break anything but the tires..

If you do it this way,, Try to make it sit on the top of the bottom lip.. Then your bolt's are just holding it in place..

Reply With Quote