Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Fabricating a tranny cross member....
View Single Post
  #14 (permalink)  
Old 02-06-2013, 06:06 PM
31ROC's Avatar
31ROC 31ROC is offline
Registered User
 
Last photo:
Join Date: Apr 2012
Posts: 264
Wiki Edits: 0

Thanks: 4
Thanked 5 Times in 4 Posts
I have no idea, (I think you are refering to "tubing"?) I have not started mine yet....but the crossmember I took off was about 1 1/4 tubing....if you look for crossmembers at the big website suppliers, ie: Speedwaymotors.com, I believe they'll indicate what size they are. Should give you a good idea. I personaly am planning to make this new one out of square tubing....
Reply With Quote
The Following 2 Users Say Thank You to 31ROC For This Useful Post:
41 kustom (02-06-2013), Trophyman (02-08-2013)