Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - finishing fiberglass with moldless design
View Single Post
  #1 (permalink)  
Old 01-21-2003, 12:42 PM
swoodard23 swoodard23 is offline
Member
 

Last journal entry: New photos
Last photo:
Join Date: Dec 2002
Posts: 182
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post finishing fiberglass with moldless design

I just layed 4 layers of fiberglass mat today and am very impressed with its strength. It was flat and still had very strong characteristics. My question is to see if anyone has any tips on how to get a good surface on it without using a smooth mold. I know you can use bondo, but there has to be an easier(and lighter) way. Perhaps something spray on? Something must be done because the surface is very irregular because of the strand mat. Any suggestions or webpages would be appreciated.
Thanks,
Scott
Reply With Quote