Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - first time resto
View Single Post
  #4 (permalink)  
Old 01-13-2013, 03:16 PM
UPandComing UPandComing is offline
B.A.M.F
 
Last photo:
Join Date: Feb 2010
Location: New York
Age: 27
Posts: 252
Wiki Edits: 0

Thanks: 2
Thanked 0 Times in 0 Posts
i have a compressor and a 300$ hvlp gun set just haven't gotten to the stage where i can spray, i was advised by the place in my local that mixes the paint to use the self etching if and only if there is more paint on the car than bare metal which there is, i WAS going to just sand blast the car completely but bc this is project that i can only work on when i have free time at home iv been sanding as far as i can. so educated me bc im no body guy by any means haha what kind of problems will i run into if i continue on this course of action? where do i find a step by step guide on how to do a successful job start to finish?
Reply With Quote