|
|
|
09-15-2011, 10:30 PM
|
||||
|
||||
|
Flooding after a long drive
Useful info about 4150holley float bowl adjustment, The primaries float must be contaminated after a 10mile drive to home the 302ci stalled but the fuel jets were still dripping down the carb.
|
|
09-15-2011, 10:41 PM
|
||||||
|
||||||
|
I`ve had them do so in less than 1 mile. You have one of four problems.
1. Fuel pressure too high, Some Holley`s can handle 9 psi so I`m told. Everyone I ever used couldn`t handle anything past 6. 2. Float level too high 3. Trash in the needle and seat assembly, which is very easy to do if the tank has excessive trash in it. 4. Base timing so low the idle is set so far open it`s pulling off the boosters instead of the idle circuit.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Short and long shaft TH350's.... and extra long too? | 383ram | Transmission - Rearend | 11 | 02-27-2009 05:08 AM |
| TH350 STILL slipping after long drive | 87442lover | Transmission - Rearend | 10 | 01-02-2007 05:19 PM |
| Front drive 3.8 Buick to rear drive trans | Chopt 48 | Engine | 0 | 04-30-2006 02:43 PM |
| How long is too long to wait after sanding poly primer before i can spray a 2k? | misteryu | Body - Exterior | 2 | 03-17-2006 09:49 PM |
| Swapping Gear Drive Out for Timing Chain or Belt Drive - Need Suggestions | horvath | Engine | 4 | 05-24-2003 08:47 PM |
