|
|
|
09-08-2008, 01:51 PM
|
|||||
|
|||||
|
gen 5 454
Is there anything from the mark iv that won't work on the gen 5? I seem to get conflicting info. My buddy lost a rod in his mark iv block and has a gen 5. Should the solid roller cam and heads work with this block as well as the pistons and rods? They way I understand it you can use the old heads with the proper head gasket.
|
|
09-08-2008, 08:35 PM
|
||||||
|
||||||
|
The fuel pump from the Gen IV wont work...there is no place for it on a gen v. Also the crankshaft is a one piece rear main on the 91 and up Gen V.
|
|
09-09-2008, 04:39 AM
|
|||||
|
|||||
|
No mech fuel pump req'd and I have an adapter to use a two piece seal. The biggest thing here is heads and valvetrain.
|
|
09-09-2008, 01:08 PM
|
||||||
|
||||||
|
I think you should be good to go. Use the fel pro head gasket #1307 it covers all the gen iv and gen v motors and has the three coolant holes already in the bottom of the head gasket.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gen v 454 marine roller motor | 71javelin | Engine | 13 | 09-12-2007 01:52 PM |
| 454 swap in a 3rd gen | chrismac | Engine | 4 | 07-29-2006 09:43 PM |
| GEN VI 454 build | badazz81z28 | Engine | 20 | 02-16-2006 10:43 AM |
| Help 454 gen 5 | t/a clone | Engine | 5 | 05-21-2005 05:28 PM |
| 454 Gen V Valve Settings | JDHBAJA | Engine | 2 | 02-04-2005 06:01 PM |
