Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Getting to around 396cid using 880 block
View Single Post
  #32 (permalink)  
Old 03-25-2013, 01:02 PM
ap72 ap72 is offline
How fast is fast enough?
 
Last photo:
Join Date: Jun 2005
Location: St. Louis, MO
Age: 29
Posts: 9,484
Wiki Edits: 0

Thanks: 20
Thanked 388 Times in 364 Posts
Quote:
Originally Posted by Hogg View Post
I do like that 7137 intake, I was looking at its Vortec brother in the past, for use with the Largeport Bowtie Vortecs.

Those heads look like they are serious parts. Do you have personal experience with that company? HAve you used these parts?

This is starting to look like a higher rpm setup now.

Any opinions on converting a 2 bolt block to splayed mains, or would stock 4 bolt mains suffice? Would you take 2 bolt mains to 7000rpm?

Thanks again.

peace
Hog
Personally I won't spend that much money on a sbc platform when the gen 3/4 stuff is so much better but there are MANY people who have nothing but good things to say about speir and his products. you can find him on speedtalk.com. If you're looking at 7,000 rpm then the heads I linked too will be too small, they're more suited to a hot street 383 than a more race style set up.

On the blocks, rpm, and rotating assembly- it depends a lot on weight and balance.
Reply With Quote