Hot Rod Forum banner

Getting the maverick in the shop, what a job

614 views 0 replies 1 participant last post by  old fords 
#1 ·
I was ready to start on the mav so I had to get the 51 out of the shop. We pulled it up on the car hauler and it went just fine. I put a battery on The mav and it finally cranks but the tranny will barely pull. Our garge has a redrock entarnce that is uphill. I attempt to back it in the shop and it constanly spins out. Try some boards under the back and its the same. We get the ramps for the car hauler and it still spins. Finally we have to pull it on the car hauler and let it roll into the shop. I have got the hood grill and rediator of. I plan to get the old 250 C4 out this weekend. The 86 roller 302 should be going in about next weekend. :thumbup: Anybody need a 250 that would used to chirp the tires going into 2nd that would now be good for mosquito fogging :p
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top