Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Getting ready for new oil pan gasket....
View Single Post
  #8 (permalink)  
Old 01-24-2013, 02:13 PM
killeratrod killeratrod is offline
Last photo:
Join Date: Nov 2012
Location: Florida
Posts: 2,440
Wiki Edits: 0

Thanks: 195
Thanked 461 Times in 410 Posts
hey if you could tig weld that thin steel pan to the cast block , You would be the best welder in the world. HAHA!! On the real note this is not a hard job. Just do not know what amount of clearance you have to remove the pan. May have to remove the motor mount bolts and jack up the motor .
Reply With Quote