Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Give me some ideas on prepping this thing
View Single Post
  #77 (permalink)  
Old 11-19-2012, 06:51 PM
novafreek6872's Avatar
novafreek6872 novafreek6872 is offline
Nova Guru
 
Last photo:
Join Date: Nov 2005
Location: Central Va.
Age: 47
Posts: 412
Wiki Edits: 0

Thanks: 82
Thanked 19 Times in 18 Posts
I wondered, should I open the cracks up a little bigger with like a sharp knife or something? To give the the putty more to grab on to? Or should I skim over the whole affected area? And If I went the skim route, should I use something like >>>



??

The putty I have on hand is Evercoat metal glaze polyester finishing putty, Im assuming that might be ok for filling the cracks, but maybe not to skim with?? Trying to figure this all out and I do appreciate the help!!
Reply With Quote