|
|
|
03-07-2006, 11:37 AM
|
||||||
|
||||||
|
GM Alternator
I`m almost ready to drop my Vortec 350 in my 86 Olds Cutlass, problem is, I upgraded to a serpentine belt system off a 92 Camaro, I was able to get a newer small GM alternator the serpentine system requires since it has a staggered bolt pattern and not straight across as the older ones were. How do I go about wiring it up? the newer alternator has a plug on it that has one large prong and 3 smaller ones instead of 2 large ones like the older ones had. Does anyone make a adapter? Any help here is appreciated.
|
|
03-07-2006, 03:02 PM
|
||||||
|
||||||
|
Doc here,
 Both Painless and Mad Electrical make an adapter plug, Mad Electrical Here is Mad's address, go to the Catalog page and check it out. Doc
__________________
Aftermarket Solutions Electronic & Electrical Innovations
|
|
03-10-2006, 09:10 AM
|
||||||
|
||||||
|
I recently did the same thing on my big block 454, droping it into my 72 chevelle. I also went with the 92 serpentine system ( talk about mods) and had really really bad alternator problems. I also switched to the new alternator. I will post where I got my pigtail, and what wires I used, as well as how to wire it up later.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GM CS130D alternator | BEAR9110 | Electrical | 10 | 05-11-2011 05:49 AM |
| GM 1-wire alternator | reland91011 | Electrical | 4 | 01-10-2005 08:13 AM |
| anyone know how to hop up a gm alternator | 406 ss monte | Electrical | 4 | 10-12-2004 05:31 PM |
| early GM alternator | 72chevelleguy | Electrical | 2 | 11-14-2003 11:21 PM |
| Do I have a GM 'one-wire' alternator? | Limey Simon | Electrical | 7 | 04-07-2003 12:31 AM |
