|
|
|
07-18-2010, 06:43 PM
|
||||
|
||||
|
GM throttle body ports question
I am putting a TBI fuel injection on a Chevy inline 6 engine and I have a question about the various ports on the throttle body:
on the front of the throttle body (towards the front of the car), there are 3 ports: one goes to the PCV valve, no problem: one used to go to the charcoal canister: what can I do with this port, plug it (since I do not use a canister on this vehicle)? the last one (small), I do not know where it used to go: can I just plug it, or what? Thanks! 
|
|
07-18-2010, 09:58 PM
|
||||||
|
||||||
|
Yes you can plug the unused ports, however, you do have a manifold port
(full time port) going to the MAP sensor I hope?
|
|
07-19-2010, 09:48 PM
|
||||
|
||||
|
Yes, thanks, the MAP port is on the rear of the throttle body, no problem here!
Last edited by wave1957; 07-19-2010 at 10:03 PM.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2.8L s-10 motor with 4.3L throttle body | catscan4free | Engine | 20 | 04-22-2009 03:12 PM |
| 1978-1988 GM G Body rear seat removal question | schnitz | Interior | 7 | 04-17-2009 05:49 AM |
| 96 to 00 5.7 Stock GM Rod Question | Mustangsaly | Engine | 24 | 11-28-2006 09:23 PM |
| Body filler question | paulsv8manta | Body - Exterior | 3 | 01-24-2006 01:19 PM |
| Jeep 2.5L throttle body to 4L throttle body. | Parisienne66 | Engine | 2 | 07-10-2005 08:35 PM |
